Ruckus ICX switching – Displaying files on USB or flash
I needed to update the firmware on a Ruckus ICX 7150, but could not remember the file name of the firmware I was updating. I looked through the commands for a dir: flash, or dir:usb and really...
View ArticleReset HP 5900 back to default
Below is how to factory reset a HP 5900. This will remove all configuration. reset saved-configuration main reset saved-configuration backupThe saved configuration file will be erased. Are you sure?...
View ArticleClik here to view.
Adding Mobile tokens to Fortiauthenticator
When purchasing mobile tokens for Fortiauthenticator FGT or a partner will usually send a PDF with an activation code. The PDF has good instructions on how to register the code, but I thought I would...
View ArticleCisco ASR “private key not found” Error
I was working on a ASR running code: asr1000rp1-ipbasek9.02.02.01.122-33.XNB1.bin. I wiped the config and started over from the last setup, and tried to SSH in. I was continually getting denied, and...
View ArticleRecover Cisco 9200 switch from firmware loss
recently I had an issue where the firmware on a 9200 switch was corrupted. This can help during an upgrade, or removal, etc. After a reboot the switch came up to rom monitor mode, no biggie I thought-...
View ArticleClik here to view.
Microsoft NPS logs not showing in Event Viewer?
One of the best troubleshooting steps for Radius/NPS is to look in the event viewer to see why you are having failures. This shows if the server is actively denying the user login attempts due to...
View ArticleClik here to view.
Enable Open wifi authentication in Fortios 7.0+
I was creating an SSID from within the Fortigate to manged Fortiaps and noticed I could not change the security to “Open”. The only options were security options, and Captive-Portal. I was like, where...
View ArticleClik here to view.
Fortinet LDAP/RADIUS Source address with SD-WAN setup
I found this a neat tidbit of knowledge that I thought I should share. Created a Fortinet SDWAN setup with many sites – works awesome. Fortinet’s SDWAN is simple, but very effective with some really...
View ArticleClik here to view.
Enabling Syslog for Cisco 9800 Controller and APs
Below details how to enable Syslogging for both the controller and APs. In the controller, it seems its CLI only (If not, please comment how to do from GUI). First lets set the Controller to send...
View ArticleClik here to view.
Fortigate – Separate IP pools out of multiple SDWAN Interfaces
Now that I setup SD-WAN interfaces in Fortigate for almost any deployment – due to future proofing. I have struggled with how to make internal resources that need to nat out publicly from a certain IP...
View Article